Finger Print module Interface
Project is ATM security based and control. If the person is authorized only then allowed to access ATM and door will open. For unauthorised person it will not allow to open the door.
In this project we will use finger print module to recognize person. After recognition it will give data to Microcontroller 89s52. Finger print is the better option as compare to other. Normally we recognize person with password or some other method. Itís the best security system. It helps to find out person identity and will display on LCD. We will use serial interface for communication between finger print module and Microcontroller . few commands required to communicate search database from module. Module itself programmed with ARM processor. Module also have fixed memory. So you donít require external serial or parallel interface for memory. We will use push to on switches to enter data. First of all we will add our thumb expressions. If all added, then there will be switch to search all. We will also use a key to delete all finger prints.
Electronics voting machine
Access control using person recognition
In this project we
Chapter 2 Technical Specifications
6.5V（exceeding this value will cause permanent damage to the module）
<80mA（Input voltage 5V）
<1.5s（200 fingerprint, average value in test）
<200ms（Time lapse between module power-on to module ready to receive
Tolerated Angle Offset：
User Flash Memory：
Standard serial interface （TTL level）
Communication Baud Rate:
Relative humidity: 40％RH～85％RH（no dew）
Finger print module sim630- 1nos.
10 k resistor- 20 nos.
BC548 and BC558- 4nos.
LEDs- 10 nos
LCD 16*2- 1nos.
Microswitch for keypad
Resistors- 10k, 1k, 4.7k
Crystal- 22 Mhz
From 8051 microntroller programming- Ayala
For Fingerprint module- www.8051projects.com
For components- Mata Rani chowk, Ludhiana and Toshankits, New Delhi